Rigging the Sail to the Spars / Mast / Boom / Sprit

Preparing deck for servos

Winch and Rudder Servo attached to the cover.

Molded servo box cover  hole drilled for mainsheet grommet

Glued Servo Box marked up to make room to put in the Servos

Markup and cut out room for the servos make sure to leave a lip to seal the servo cover once it is attached.

Trim the servos cover to extend over the cutout enough, use adhesive sealant foam tape, you can score the cover and break off the excess.

Cutout for switch, place battery using Velcro so it can be easily removed. Notice the receiver adhered to the bottom of the rudder servo. You can place it anywhere just as long as the cover will close.